Fireplace 4U - Custom Corner Fireplace
Home :
Fireplace Cleaning Tools Articles and Resources :
Sitemap
Custom Corner Fireplace
Considering a Fireplace Insert
Submitted by jcstoner
Old fireplaces can present a challenge when it comes to rehab or renovation. One of the most popular approaches is to upgrade with a fireplace insert. Most homeowners aren't familiar with all the options that are available today in fireplace inserts. It would be worth your while to explore the possibilities. You can find styles and models that would fit any décor you are trying to match. The modern fireplace insert is designed to provide an elegant look and at the same time greatly improve the operating efficiency of that old fireplace. Most are made of cast iron or steel and come in a variety of sizes to fit most old fireplaces. If worse comes to worse they can be custom built but will be more expensive. The next decision you will need to make is the choice of fuel. Wood, gas or propane are the most common and the ones usually recommended.
Today state-of-the-art technology is used in their manufacture and many have additional features including blowers, fans and thermostats. They provide a good way to help lower utility bills as well as adding charm and ambiance to any room.
Most older homes with wood burning fireplaces can benefit from the installation of a new fireplace insert. These older fireplaces have very low heating efficiency primarily because of the open combustion design. These open fireplaces draw to much air in and burn to quickly wasting energy. The fireplace insert with its closed insulated doors slows the fire down, increases the temperature of the fire resulting in a better more complete combustion. This higher efficiency will have a noticeable impact in reducing higher home heating bills. If you choose an EPA-certified wood burning fireplace insert, it can reduce wood burning emissions almost to zero.
There are several important considerations when you are selecting a fireplace insert. While there are a variety of fuel types available - wood, gas, propane, pellet and coal - the availability and cost of the fuel source is of prime concern. Availability and cost of fuel types can vary widely across the country.
Getting the right size is one of the most important issues you will have to deal with. Getting this right will save time, money and frustration when you go to install the insert. The size of the fireplace insert obviously depends on the size of the existing fireplace opening. But there are several key measurements that need to be made to get the size right. You will need the front opening height and width. Measure the depth. Measure the width of the back of the fireplace. Most fireplaces are narrower at the back. Finally, measure the depth of the hearth in front. Some inserts require a minimum hearth depth.
Consider the location. A fireplace insert needs to be used in an existing masonry or factory built fireplace. They are either vented naturally through a working chimney, direct vented or vent free depending on the fuel used. In most cases, a chimney liner is required for naturally vented fireplaces. Make sure to check on all building codes before installing.
From contemporary to traditional, fireplace inserts come in a variety of styles, colors and finishes. What ever you choose you can be certain that special fireplace insert will spectacularly transform that old drab fireplace. It will add true value to your home for years to come.
Custom Corner Fireplace News
Sunroom distinguishes Tarrytown home (Austin American-Statesman)
What: This warm and inviting home sits on a corner lot in Tarrytown, only a few minutes' walk from Hula Hut, Mozart's Coffee Roasters and the Oyster's Landing Marina on Lake Austin Boulevard.
Read more...
Golf: This is no longer just your father’s game (The Joplin Globe)
I was flipping through a 1986 golf magazine the other day when I came across an article about what clubs the touring pros of the time were playing and the importance placed by equipment manufacturers on assurances their signed stars actually were using their wares.
Read more...
It’s time for Ozark bass to feed ravenously (The Joplin Globe)
Two years ago at the end of September, about 6 or 7 in the evening, I was fishing a lonely stretch of river that is far from any public access where it was quiet and still.
Read more...
